i was riding my peugeot speedfight 2 to the petrol station and i notice my speedo had stopped working, when i got to the petrol station i switched it off and filled up, after this when i tried to start it i noticed the electrics for the rear brake dont work, when i pull the rear brake the brake light doesnt come on and i have to hold the brake to start the ped usually but now it wont do anything if i hold the rear brake would this just be a loose wire? also where are the wires for this (the connections)

josh-with-the-peugeot, February 2011

Hi
My spedo was wotking fine until I took my wheel to pieces of my 2005 pug speed fight any help ???????????? And now it ain't working

jack beattie, September 2012

thanks mate but i meant the speedo isnt telling me my speed and miles arent going up

josh-with-the-peugeot, February 2011

josh the front and rear brake both have a micro switch that puts the brake light on when you pull the brakes on,you can start the bike by pulling either brake if they are both working and they should be for safety and for an mot too.the two switches are screwed into the brake lever assemblys under the top panel at the front on the handlebars and have two wires on each switch,the switches are about £5 each.the speedo instrument bulbs are totally seperate and use small capless bulbs that lock into a plastic bulb holder and twist into the back of the clocks on a flexible circuit board

adam bike doctor(of milton keynes motorcycle centre), February 2011

i know it is loose connection, do the speedo and brake have seperate electricity connections? also where are they??

josh-with-the-peugeot, February 2011