Hi,
During some renovations to my property, I accidently disconnected the Panic Alarm button (disconnected from the cable) on my "Paragon E" alarm from Pyronix. Now whenever the alarm is set, the Panic Alarm triggers immediately. As it was never used anyway, is there any way from omitting the Panic Alarm from being activated when the alarm is set, and if so how do I go about this?

JEvans1977, May 2011

There will have been two wires going to the panic button. Twist them both together and tape them up. The panel should set as normal. For a permenant job open the panel and put a LINK across the terminal marked PA in the panel. If it goes off when you open the front just put your code in and dont reset until the front has been refitted

Geoff, May 2011

Go to the panel, remove the fuse to the spur. open panel find panic alarm circuit, put in a link and then close up and then replace fuse.
Job done.

Alarm, May 2011

Yes, accidentally disconnected by removing the cover (this triggered the alarm, but I was able to reset it) If I replace the cover I will need to find a way to hide the box (like I say it is never used), so instead I'd rather just be without it. Thanks.

JEvans1977, May 2011

for a start,no one accidently disconnects a panic button,you have to remove the cover,why not just reconnect it?or is that too easy?

gts, May 2011