1. remove the two heater feed pipes in the engine bay. (best from underneath the car).
2.remove the centre console.
3. remove the three screws located on the black unit one on driver side and two located at back underneath unit
4.undo clips one on each side.
5. remove screw from air duct and push airduct up to retract it.
6.undo metal bar held by a t40 screw
7. undo clips two each side of the matrix housing
8. remove matrix and housing in one
hope this helps
you will need a t20,t40 star screw driver bit, possy screwdriver and that is about it
stuart, May 2005
