Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

fuel line replacement poulan wild thing?

The fuel lines were completely destroyed inside so I need a diagram as to which line goes into which hole which is the intake and which is the outlet, etc to replace the lines and filter in the tank. There are two lined attached to the carb and two to the bulb pump, which also needs replacing. A drawing would be of great help
george moore, December 2007
This may not go through as I find out most of my answers are not added, maybe I answered too many?
I really think some of the machine are crazy. The rear tube has the adaptor on it or a coupling and the front one is smaller and has the filter on it. The rear tank tube goes to the large primer bulb inlet. the small primer outlet goes to right side of carburetor or older models upper inlet on right side. Front tank tube goes directly to carburetor on left side of lower right side. If the engine runs about 5 second and quits every time you prime it switch the two tubes on the carburetor. If it only runs a tank or two and will not start, the primer bulb may have gone bad if it will not pressure up, If it still no work, maybe it needs a carburetor kit. Make sure it has a spark. If this fails, consider a large heavy hammer. It takes patents with the new stuff. The alcohol in the gas is why everything falls apart.

pinkpanther, April 2008