I have a 1995 Toyota Carina E, 2,0 but the allarm / immobiliser has cut in. I've tried all the tricks in the toyota book with no success. Any ideas welcome.

jim kerr, December 2007

Just done this on a 95 carina e easy to do i took off the right hand kick panel found the end of the imobalizer loom i found male and female plugs on the end of the loom there are seven plugs with six of them you disconnect the one going to the fuse board from the imobalizer loom then put the other car loom plug that plugs into the imobalizer loom straight into the fuse board do this with six plugs no7 plug has thin wires this plugs into a socket thats set back a bit against the inner wing we did not have the alarm shut of key so we took the alarm horn apart and cut the wires to silance hey presto away we go 10 min job.

steve gee, March 2011

there is a white 4pin plug attached to the imobaliser you can unplug this to get the car to start. its located close to the ecu under the nearside footwell. this will get the car to start but some electronics like the radio. will not work.

after that take it to a toyota garrage to get it re programmed.

jon the king c, July 2008