andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

veritas R8 outside bell?

why does the outside bell work on full set, but not on part set
trevor archer, December 2007
Hi Trevor,
This is because the settings havn't been changed during programming from internals only on part set alarm
To switch this mode off do the following:
1-ENTER ENGINEERING CODE (factory set 1234)
2-PRESS PROG
3-ENTER 01 (misc selections one)
4-ENTER 2 PRESS PROG (this switches it off)
5-PRESS RESET to exit programming

John, December 2007
link Click here to see other fixes for Veritas R8.