I have cleaned the filters,condensor checked the thermal contacts in the back of the dryer with the fault on they are ok,the heater elements glow to heat,checked the wiring could it be the timer? once it has cut out it will not start again for a bout five minutes.
it is a creda condensor tumble dryer model t620cw

mark freeman, January 2008

Have a look at the On/Off relay under the top panel, It's probably a defective armature coil

Normsky, February 2009

This is mark freeman still no luck with tumble dryer will update if I do,tryed it again after a few weeks still the same

mark freeman, February 2008

to mark freeman did you fix this problem. I have a creda T601CW with the same fault

andy lennon, February 2008

From looking at various sites on the Internet, it looks as though this is caused by a faulty or damp heater in the drier. The advice seems to be to leave the drier to "dry out" for a while (i.e a couple of hours). If the fault is not resolved, then leave it a little while longer. If the fault persists, then the best advice is to get an engineer to look at it. Sorry I can't be more specific.

floyd, February 2008

just wondered if you'd had any luck fixing your dryer as i have the same make and the same problem?

sarahmarie, January 2008