Find the location of slave cylinder on the flywheel housing. you will need the following, a small jar.a length of small bore pipe to fit over the nipple end TIGHTLY,a ring spanner to fit the bleed nut TIN BRAKE/CLUTCH FLUID.
Put some b/fluid in the jar about half inch will do attach ring spanner to nut (ring end) attach pipe to nipple place jar where it CANNOT move or slip immerse other end of pipe into fluid.
FILL the reservoir with fluid to the top open the nut a couple of flats only,now press clutch pedal down/up 3 -4 times close nut, remove jar and pipe. Check the fluid height in reservoir, top it up to the high MARK Is the clutch clearing with the engine running if not bleed slave again .DO NOT reuse the fluid in the jar as it contains air .
wirecutterman, January 2008
