How do I replace the drive belt on my Hotpoint TS12 tumble dryer?

How do I replace the drive belt on my Hotpoint TS12 tumble dryer?
Mrs June Jones, June 2005


done
We are trying to replace our belt on the ts12, we have followed your instructions, but we are having problems as the belt isn't tight, I ordered the correct replacement, so we are at a loss on what to do
Any help welcome

Jsandi86, October 2018
Followed the instructions and they were very helpful. The only thing we struggled with was getting the belt back over the drive shaft. We used a short length of copper pipe which worked really well. You need to put the pipe through the belt at the bottom then attach the pipe over the drive shaft, use the pipe as a lever and slide the belt along the pipe until it gets near the drive which should still have the copper pipe over it, with one person each side of the dryer, use a screwdriver passed between you and held at each end to help move the belt along. when you get near the jockey wheels, pull out the one nearest the right side of the dryer and keep moving the belt along (this IS hard work) don't panic and do it little by little, when in line with the right jockey, start to turn the drive shaft using the copper pipe, the pipe will probably be at a slight angle, this is ok, the belt should start to move along towards its final position. Keep turning the drive shaft until the belt is aligned with both jockeys then remove the copper tube. The belt should now be on the drive shaft. Hope this helps.

west1871, October 2012
Thanks for the instructions - just what I needed.

Biltong, February 2008
Hi, I just replaced the belt on my TS12 dryer. It's fairly straight forward.

First, pull off the timer knob to reveal a screw behind it. Remove this screw (this caught me out for a while)

Next, remove the 4 screws on the bottom of side panels, then the 2 below the main front panel at either edge. Finally remove the two screws at either edge at the rear (You don't need to remove the ones at the top edge in in the center.)

Now, gently slide the control panel at the front to your right as you are facing the machine, it should move about 5mm to the right and then be possible to lift forwards, revealing several more screws.

Remove the screws at the top and the sides that were under the control panel.

Once this is done it should be possible to lift the main white metal bodywork straight up away from the front panel and the rear panel to reveal the drum inside.

Once you have the bodywork removed, locate the tensioner below the drum that keeps the belt tight, pull the arms apart and remove the belt from the motor.

At the top of the dryer above the drum you should see two metal bars that connect the front panel to the rear held in place by screws at the front. Remove the two screws to disconnect the bars. While supporting the drum, gently lean the front panel forward enough to slip the old belt past the front of the drum (I found it helped to open the door at this point as the filter gets in the way with it closed. Once you have removed the old belt, pass the new belt around the drum in the same manner.

Work the felt bearing back into the drum and close the door, then replace the two screws that held the bars in place to prevent the drum falling off the bearing.

Replacing the cover is now the reverse of removal.

Hope this helps,

Andy

PhazeShift, November 2005
Did u get an answer? Also stuck :(

WB, October 2005
link Click here to see other fixes for Hotpoint.