2 hours ago andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

DX310 Dishlex Rinse Light Flashing but it is draining?

According to manual, flashing "Rinse" light means the machine is not draining. My Dishlex DX310SA is stopping during the initial cycle, "rinse" light flashing, but the machine is fully drained.

When you clear the machine and reset, the drain pump runs for a long time (dry), and then rinse light flashes again.
This repeats a few times until it eventually resets.

Have stripped and cleaned all fittings, filters and hoses, and drained hose directly outside to ensure no plumbing backfill issues.

So my quesion is...Is there a water level sensor arrangement to indicate the machine is drained? or could this be a more serious problem like a control card etc?

Keen to get some idea before calling out the repair man on hourly rates...
Adrian, February 2008
And I have found the answer!.
For anyone who may be interested...
There is a small plastic filter in the drain pump underneath the unit. It has a large outlet, and a small inlet, and was full of sludge.
To get to it you need to take the kicker plate off the bottom, undo the screws on the front of the plate to get access to the pump motor etc. The clear plastic container is at the front.
It unplugs from the pump and has another small hose which is easliy removed.
Once cleaned, the machine works like new.
Woohoo!.

Adrian, February 2008
link Click here to see other fixes for Dishlex DX310SA.