On most programs the machine halts on Rinse&Spin, with the water still in the machine. It will pump out if Pump Out is selected manually, but then will also halt on Fast Spin when selected manually.

Any suggestions? I have fixed older Hoover washing machines in the past, but I think that this thing has a computer. Is there a way to reset it (I've tried cutting the mains power, then turning it back on again).

Thanks

John B, February 2008

Just had the same problem, and found 4 buttons, a small sock, a lot of my wifes hair, some collar stiffeners and other junk in the pipe coming off the drum before the pump - cleared it and problem solved

gaz c-n, July 2008

Some machines test the motor rotation and if this is abnormal they throw a wobbler. Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.
Check the pressure switch - a round item about 3 inches across with several wires connected, it sits under the top cover. Its an air operated switch which tells the machine water has reached the correct level. Disconnect the thin rubber pipe from the switch and blow down through it to clear any blockage. Switch itself may be faulty but its more likely the pipe is blocked.
Also check the filter - generally located behind a panel at the foot of the machine.Some are obvious like little square hatches and some are hidden behind the trim panel at the foot of the machine.
Check out this site for spares : www.4directelectricals.co.uk
Check out this site for info: www.2ndwave.co.uk/manual.html

dan, February 2008