I have a WJD1457. When the machine moves on to the drying cycle it runs for about 5 minutes then an E10 error comes up. This was an intermitant fault, but now has become permanent. I checked the water inlet and thats not blocked, nor is the hose kinked. Anyone know what else it could be and if so what part(s) to replace? And where to get it/them. The machine still washes fine.

Ian Wilson, March 2008

water inlet has 3 valves.you might find 1 is open circuit should all be 3 to 4 k ohms.also remove black hose from the middle inlet valve,the one that goes to back of soap draw into a square piece from underneath.blow hard down pipe to unblock valveas they scale up.try this and if fault still happens post again as there are other things to suggest

ck, March 2008