my washing machine gets half way through a wash and sends some lights on the front flashing.

on/off flashes along with reduced creases and mini load.
(lights 2 and 4 out of 5 vertically)

i opened the pre-chamber to the pump and there is no debris present.

any ideas ?

biggaz555, March 2008

there is mains at the power socket. when the machine is switched from the socket the lights momentarly flash on tne machine but I cannot power on the machine using on/off switch. I can hear the switch click when depressed.l

mbmb, July 2008

Cant find this particular one in my data sheet, so you just have to go through this list. Power off.

1. Some machines test the motor rotation on power up and if this is abnormal they simply abort the program. Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre possibly worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.

2. Check heater with a multimeter. Heater is located at bottom of drum. Disconnect wiring and take resistance reading. Should be round 20 ohms. Blown heater will give infinite resistance. to replace, undo central mounting nut and prise it out of its rubber seal - may require some effort. Replace heater, use sealant when refitting rubber seal and ensure it is fully pushed into the recess in the backplate.

3. Check water level pressure switch. the component that determines correct water level in the drum. Its a round item about 3 inches across with several wires connected, it sits under the top cover. Its an air operated switch which tells the machine water has reached the correct level. Disconnect the thin rubber pipe from the switch and blow down through it to clear any blockage. Switch itself may be faulty but its more likely the pipe is blocked.

4. Possibly a duff connection on one of the board connectors. Power off, remove covers, disconnect circuit board connectors and clean with toothbrush. May help to tighten them with a pair of pliers. Clean off any corrosion or crud, refit and test.
Check out my site for info: www.2ndwave.co.uk/manual.html

washerman, March 2008

the lights are flashing a code, it would help if you told us which neons where flashing.

asuds@hotmail.co.uk, March 2008