jason asked ... Daf cf 85?    |    Roger Kipp asked ... Jvc th-505?    |    Paul Dennis Newman asked ... Gardenline GLS 36K scarifier?    |    Cam Tait asked ... How can I fix my Bison 50 stair lift?    |    GG asked ... Fix food processor motor?    |    Click here to ask your question

Increasing water flow from taps?

I live in a rented flat. The cold water for the kitchen sink is provided from outside. This runs very fast! But the water that comes from the tank/boiler (on the same level as the flat - we have it in a small airing cupboard space) runs very slowly. So slowy and without enough pressure that i cannot stand up and take a shower as the water just won't go up that high! The shower hose will only work up to 3 feet in the air. The same goes for the hot water in the kitchen. Its very hard to get washing up liquid bubbles etc!
The boiler does not provide central heating as there isn't any - all the hot water is done by an immersion heater. Theres no problem with the water temprerature though. Its only the internal pressure thats a problem.
As i mentioned my flat is rented and the landlord said that he had the same problem when he lived there and he thinks it's from when the flats were built. But being rented theres not necessarily a lot that we can do. But is there anything we can to improve the situation???
Hils Parker, October 2003
The outlet pipe on the top of you hot water cylinder is blocked.
Turn off the water supply open a hot water tap until it stops, remove the connection and you will find it and possibly the pipe is solid with scale.

Derek, June 2004
I helped someone with a similar problem, that had me baffled. I started by clearing the scale from the ends of the taps, but this had no effect.
Turned out that a bit of fibre wadding from the header tank insulation had dropped into the water in the tank, and ended up stuck on the tank outlet. One cold wet arm later - problem solved.

BobG, May 2004
This is a simple case of the head from the supply cistern being to low to give enough flow.

The solution is simple get someone to install a shower pump! Cost about £200-£300.

Tony Glazier

Tony Glazier, January 2004
cheers, will look into that, thanks!

Hils, December 2003
On the main water inlet to the boiler or water heater you can add a pump to increase water flow into the boiler/heater .. the problem is that there not enough pressure to push it out when showering/ use.. to refill it. Check your local plumbing store for booster pumps and flow switches this might resolve your issues. The only other possibilities is the iron deposits due to heavy water has built up and not allowing good flow.. This you might have to replace lines/ pipes.

Bob, November 2003