the fridge no longer works i need to reset the fridge so the gas burner re ignites. does anybody know the workings of norcold rv fridges? the model is a norcold N611

Phillip Searle, April 2008

this is the easiest way to reset your N611

HJH, August 2011

Rick, YOU ROCK!!!
My husband and I got a free n611 from someone that said the board needed to be replaced. We hooked it up, got the 5 blinks and I hit the internet for the answer. You were the one that saved the day. A free RV fridge and nothing is wrong with it. Thanks! Your instructions were simple.

Jacky, November 2008

2 different explanations of how to reset your N611

1. If you go to the outside and pull the black cover off the board and reconnect the wires, then have someone inside turn it on and you will want a jumper wire going from the number 15 pin or to describe it better it will be the open connector next to the white/ purple wire or like the second hole on top from the left. You will want to jump it from that pin to a ground for about 15 seconds or until you hear it reset. You will hear it do this too. If this is not clear enough for you I recommend that you take it in to have this done. Doing the wrong spot is bad for it. I hope this helps, Bill

2. To reset the circuit board you open the panel to the circuit board on the refrigerator. Look for a white wire with a purple stripe. There should be an empty
socket on the plug to the right of the white and purple wire. Take a paper clip and place it into the socket and ground the paper clip. YOu should hear a clicking sound. Your circuit board should be reset if it is still good.

Rick, September 2008

I have the same problem how did you get yours fixed (reset)?

nick blea, August 2008

Hi we had the same problem with ours according to the hand book you have to take it to a service center to get it unlocked

Troy, May 2008