enter your master pin (pin#1), push the * key, enter the digit "0", then push the # key. the power service and arm light will slowly flash.
enter the user number (if one alarm number enter 1) and push the # key
enter the user new pin and push the # key. the new pin number must be four digits long
enter the new pin number again and push the # key
if the pin accepted the key pad will beep twice if you make a mistake the system will reject the new pin and will beep five times try again
if no key is pressed for 5 minutes the system will automatically exit the progamming node.
exit the programming mode by pushing the * key, them the # key. try the new pin good luck frank
frank, April 2010
