My washer just stopped spinning, i think it went through the wash and rinse, the pump is working (i can hear it) and it's not blocked, i removed the top of the washer and the belt seem's ok, i don't know how to get to the motor to check that can you tell me how?, i am trying to eliminate what it could be, can you please help?
Kind regards Julie.

Julie Moore, June 2008

A Great big THANK YOU to Colin, following your instructions i managed to get to the motor easily and found it was the brushes i have now fitted new ones and the washers working perfect again. Once again THANK YOU. Julie.

Julie Moore, June 2008

the cabinet splits into take lid off and you will see 6 brass screws 3 each side you only need to undo 2 each side the ones towards the back also at the bottom of the back cabinet thre will be 2-3 silver screws to undo and 1 at each side at the bottom under plastic covers. then where the water pipes and mains cable are un need to unclip that plastic housing. hope this helps

colin, June 2008

tip machine back and you will see the motor its at the bottom . check motor brushes

www.asuds-appliance- spares.com, June 2008