I have had the same C6 error code on and off for a while now, have just tried the diognosic test above and it shows C6 when in the wool 40 degrees position so does this indictae i need to replace the pressure switch?
I also had the C7 error a few weeks ago but it didnt show up on the diognostic test so should i take it that it may have cleared itself?
kat simmons, August 2013
Hello Blobby
I too have same error code C6
Could you give me some more info re: pressure sensor please?
I have two units on my 88730-w one is brown and attached to the centre strut, and the other one is black and attatched to the right hand side panel just behind the centre strut. Both units have electrical connetions and hose inlets. Do you know which is the analogue pressure sensor of these two components?
Also could you reccomend a good supplier for spare?
Cheers
Kandra
Cheers
Kandra, September 2008
C6 is the analogue pressure sensor. It's on right of machine looking from the front just behind the centre strut. Clips out easily £20.
Selector to off. If you hold the top 2 left buttons in then turn selector 1 click to left it enters diagnostic mode. All lights come on for test and buzzer sounds. Then click selector one click anticlock at a time and it tests each system and gives an error code if faulty.
