Hi there, my Zanussi WJD 1457W was coming up with error code E10 when using the tumble dryer. I read on this forum that it could be the 3 way sensor and my hubby replaced this. We now have no error code coming up and the tumble dryer is going through its cycle no problem but is not heating up. I can feel heat above the door but there is no heat in the drum. Does anyone know if there is a reset button that needs to be pushed as I've again read elsewhere on this forum that some models have this, we've looked to no avail however.
thanks in advance

Mrs W, June 2008

my wjd1667 washer dryer isnt drying. I have replaced the pump belt,and thermister as well as cleaned out the condenser tank. the heater elements both have the same degree of resistance and I have checked and pressed the reset button on the rear stat but the problem has not been cured. help!!!!!!!!

Dave Clarke, July 2012

Hi ck

thanks for your speedy response. I'm not quite sure what stat is but will have a look tonight and let you know the outcome.

cheers

Mrs W, June 2008

there is a reset button on the dryer duct (red pop out pin on the stat attached to back left stat).also remove the back half of the cabinet an look at the condenser tank down the right side as you look at the front of the machine.theses block up and cause no air flow

ck, June 2008