how difficult is it to remove and rebuild the saxo vtr gearbox, suspect diff blown, any help would be appriciated.

simon brocklehurst, June 2008

how do u rebild a gearbox

callum, July 2009

jack it up or put it on a ramp, rip the old box out.. . check ur clutch is clean of oil. ring round scrap yards. slip a secondand box in out of a xaravtr 1.4-210 or a saxo.. . . go no smaller than a 1.4 or the gears will be different

GrAnt., June 2008

HI i rebuild gearbox,s for a living and have done for over 14 years now and i can honestly if you dont know how to build a gearbox and you have,nt got a full tollbox and access to a hydraulic press and pullers and bearing splitters i would,nt attemp it.
I,m sure you could take the gearbox out and then refit it but id give the rebuild i miss if i were you.
Richard
rbtrans@hotmail.com

Richard, June 2008

Simon, unless you have access to specialist tools and the knowledge you are better off leaving it to the experts

paul, June 2008