4 hours ago Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

How can i fix my Hotpoint ctdoo?

Will not blow hot air
Desmond Hall, June 2008
what a man that archie b is wife said you can have a big hug , as going on hols weekend and dryer just packed up , 2yrs on from your post and m8 it works again well done you saved me a few bob there both in not haveing to go and get a new one and paying out to get it dry big hugs and kissis from the other half

mick, August 2010
sounds like your thermal cut out switch has been activated ,you may be able to reset this rather than replace it ,you will find it by removing back cover of machine pretty sure it`s sited behind heating elements and held with 2 screws on rear panel ,there will be two cut out switches (disc shaped about the size of a penny with 2 spade connectors)on one of the switches you will find a small hole press a pin through this hole till it pushes the face of cut out switch back out ,you should hear it click.that should fix it.

archie b, June 2008
link Click here to see other fixes for Hotpoint.