Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Veritas 8 alarm panel code changing?

Hi,

I hope someone can help me on the following two points.

Firstly. On the Veritas 8 I believe that the correct procedure for changing the factory set ENGINEERS code is as follows. Enter existing 4 digit factory set engineers code, Press prog, press 60, enter new 4 digit code, press prog, press reset.
Could someone confirm this please.

Secondly. How do you change the factory set USER code ?

Many thanks in anticipation.
Regards,
Alan.
Alan, June 2008
Thanks for your help.

Regards,
Alan.

Alan, June 2008
Yes you are correct

The procedure is the same for the default user code.

Alarm Engineer Bristol, June 2008
link Click here to see other fixes for Veritas 8.