Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

cant change code on veritas 8c?

existing code wors ok
only tried to enter one new code
Enter your existing 4 digit code.
The Unset light will flash.
Press Prog
All the zone lights will illuminate...
at this stage the zone lights dont light up
i have followed it to the end with no joy, it reverts back to the original code,
thanks
ian, June 2008
Enter old code
Press Prog
All lights lit
Enter 6 0
All lights go out
Enter new code
Lights 1 2 3 and 4 light with each digit of new code
Press Prog
Musical tone if successful
Press Reset

Alarm Engineer Bristol, July 2008
There are 2 versions of this panel.
ukpanels will have the both manuals for you.

John, July 2008
try the engineers on ukpanels.com

www, July 2008
link Click here to see other fixes for Veritas.