Does anyone know where I can get a keypad for a Pyronix Paragon 2 ? ref: RKP2

dave Anderson, July 2008

The cause of the malfunction appears to be repeated use of the same 4 buttons. Simply reprogram a new code using none of the original numbers. I have just done this to mine after 10 years of use and the buttons becoming difficult to use.

chris spain manchester, October 2013

To repair the Paragon Super II keypad you will need a drop of cellulose thinners and a silver conductive pen (Available from Maplins). Disconnect the wires from the back of the kepyad making sure the + and other wires do not come into contact, remove the two small screws at each side of the pcb. Lift off the pcb and you will clearly see the contacts on the underside of it.

Dampen a cloth with thinners - do not over wet it, and gently clean the contacts. Similarly clean the little black conductor spots on the inside of the actual keypad. Then using the pen, gently apply a drop of the conductive silver on to each dot on the keypad so that the surface nis completely covered. It helps to dip the tip of the pen into thinners before you do this so as to dilute the silver and allow it to spread.

When fully dry rreassemble the parts of the keypad and re connect to the control panel. This should cure your problem.

Mike Batchelor, alarm engineer Nuneaton, May 2013

Hi alarm eng. in Bristol,
if the other guy does not want your s/h keypad, I will buy it from you, how much? posted to wf8 1rt.
mine is built in the control box, is yours the same? or is it a seperate unit? if seperate will it wire into my control box? thanks Sandy.

S.Smith, February 2010

Don't know if they still make Paragons try Alarm Supplies - Glasgow - 0141 353 1354

don, July 2008

Not sure about a Paragon 2 - I have a second hand keypad for a Paragon plus.

Alarm Engineer Bristol, July 2008

Could try Ebay or phone local suppliers, see if they have any on their dusty shelves.

Rw, July 2008