3 hours ago Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    Click here to ask your question

How do I bleed a clutch on a ford transit 2000 front wheel drive?

How do I bleed a clutch on a ford transit 2L diesel front wheel drive?
Jeff, August 2008
there is no bleed nipple on cylinder at gearbox end so how do you bleed system

tony, September 2009
you will need to remove clip that holds hose into slave cyl, pull out hose about 1/4" attach hose to plastic nipple [to catch lost fluid ],then get someone to operate pedal until air clears,push pipe in and refit clip.

k, August 2008
hi i've always found the easiest way is to fill up the brake fluid resevoir which supplies the clutch master cylinder. then open the bleed nipple and let it run out 4 a couple of minutes. the other way is to back bleed it with an oil can. if you do it this way make sure there is no oil left in can fill it with brake fluid attach it to the bleed nipple with a piece of pipe and pump it till you have no air at the resevoir

ash, August 2008
link Click here to see other fixes for Ford Transit.