Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

Hotpoint Aquarius CTD40 condenser?

Everything appears to operate as it should but element does not operate. Machine out of warranty but only used about a dozen times. Element in good condition. Any ideas?
J C, August 2008
Remove the Element cover at the rear of the machine. Above the heating element is 3 thermisters. One of these (an end one) has a small hole in the rear. Press a pin into this hole and it will click as it resets.
However, there is a reason it has tripped and it may be that the bearings are failing.

DaznJen, November 2008
the chances are that the thermostats have cut out

jdv, August 2008
link Click here to see other fixes for Hotpoint.