Hi Mike, F2 on these machines is a flooding fault.Take off the wooden plinth and then there are 4 small torx screws in the plate at the front plinth of the dishwasher.Take them out and the front will fall away. Look inside,the base will more than likely be full of water.Drain this with a sponge.Be careful as the front edge is really sharp.Turn to a programme and you will more than likely see water spraying from the top hose of the motor.This results in a new motor.Average £120 plus vat and post. If there is no water in the base.Look at the black pressure switch,take out the filter and look right in the machine.This may be blocked up with grease.This is a twist and pull job and much cheaper.Again be really careful of the very sharp edges. Hope this is not too much info.All the best
Foxy, August 2008
