How do I remove the circuit board from Dyson CR01 memory?
I have fault 11 on my machine. Have done some research and found out that it's probably a blown fuse on the circuit board. I've removed the back panel, but find it impossible to get the circuit board out. Does anyopne know how to do it? Thanks
got a error code on dyson cr01 caution high water level can anyone help with this is it a faulty pcb and if so how do I get to it or can I turn water supply to washer off and reset this
collette guest, July 2014
firstly take the back of machine with a small star screw driver. next as you look inside bottom right you can see the circuit board if it is a little dark tilt the machine forward as this makes it easier ti take board out. there is 2 plastic clips holding the board on pull the board away from them as it makes it easier to pull all the fitting away from the board little tip at the front of the board number the 3 white fittings as you pull them of one by one and the one at the back of the board if you slowly turn the board on its side you can easily pull them of slightly tight but can be done . when you have the board off you can see the fuse i changed this but still got the same error code so will have to pull it all out again and change the retifier . went to my local maplan shop got a pack of fuses for £2.13 and enquired about the rectifier should cost abot £4 max you can buy it on ebay for £14 but the local shops are better if you want o buy a new circuit board it will cost abot £90 on ebay if you cannot solder the new rectifier on let you know if this solves it.
