Hi all,

I have moved in to a new house, which has a control pad with Accenta written on it and a control/power box underneath the stairs with G3 written on it.

The previous owners gave me the (single) code to arm/disarm the alarm. How do I change the code so the estate agents and previous owners don't know it?

Help!

Amit, August 2008

Thanks Alan, that worked fine.

I note that the sensor in my lounge doesn't work and the light for it on the controller doesn't light either, even though it's supposed to be active re Prog 1 + Prog 2. How can I test this and/or activate it if it has been turned off?

Thanks

Amit, September 2008

Hi Amit,
Press the keypad (PROG) button.
Enter your user code XXXX

The TA (Tamper) indicator will light and the Day indicator will go out to indicate that you are in Programming mode.

Press 8 on keypad to select User Code reprogram.
The Attack and Zone indicators 1 to 4 will be lit to prompt you to enter a new code.

Key in your NEW CODE XXXX
If the code is accepted the system will produce a series of rapid beeps.

Press (RESET) to exit programming mode. The TA (Tamper) indicator will go out and the DAY indicator will light.

Example:-
If say your USER code is 0123 and you wish to change it to 5678 then:
Press buttons PROG 0 1 2 3 8 5 6 7 8 RESET

You should now be able to set the alarm using the new code then change it again as required.

Alan, August 2008