Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

Hotpoint WMA 10 controlboard?

I replaced the control board for the washer but lost my notes telling me which part of the board the red black and blue clusters plug back on to. the choices are 2 6 9 and 11. I think the red goes to 2, but cannot be sure with the blue and black wires.
Can anyone help, what will be the signs if i do it wrong?
Gary, August 2008
My husband has just taken ours off to replace it and the order was from left to right:
1-2 x2 double red
2-1 double black, double blue, double blue, double grey and then double red
10 -1 single block of ten
Hope this helps you out!!
How much did you pay for your control board and how much was it? Cheers.

Shell, August 2008
link Click here to see other fixes for Hotpoint.