I have a 2002 ford transit RWD and have fitted a clutch slave cylinder and im having serious trouble bleeding out the system.any tips?Ken

kenny 99, September 2008

try this ( u need two people),
1, fill the clutch master cly with brake fluid
2, open the nipple, get the assistant to push down the clutch pedal and hold it,
3, now close the nipple. then get the assistant to lift the clutch pedal up fully.
4,repeat steps 1, 2, 3, and u should get a pressure
if u need any more advise i can be contacted on
ziamotors@hotmail.co.uk

zia, September 2008

remove clip holding clutch hose to slave cyl, pull out pipe about 1/4", bleed untill no air from plastic nipple push pipe back in refit clip top up fliid.

k, September 2008