Only through Fisher and Pykel. To answer your question about the removal of the drawer PLEASE READ ENTIRELY BEFORE PROCEEDING.(TURN OFF THE POWER) There are two round pins at the bottom of each side of the drawer. Take a pair of needle nose pliers and turn the pins clockwise, until they are facing vertical. genlty remove them with the pliers. You may have to use a slight bit of force to pull them out. When you have them removed, directly below each of the pins(clips) there is a tab on each side. With gentle pressure, push them in at the same time and pull out and down on the drawer face. This should free it up to be able to remove it. Be sure to remove the green ground wire clip from the drawer face in order to completely free up the face of the unit. When you have completed your repair, To replace the drawer face,make sure you re attach the green ground wire. Insure that the body molding tabs on the top of the drawer panel go behind the door face. replace the door face one side at a time and replace the pin on each side(one side at a time. DO NOT TURN THEM INTO THE VERTICAL POSITION YET) insuring that they go back the same way they were when removed.
Once you have tem both in, and the drawer front is flush all the way around, place the pins into the horizontal position. You are done.
kolt100, October 2012
