I HAVE A SHARP XE-A203 AND I HAD TO CHANGE THE TILL ROLL BUT IT WILL NOT GO BACK ON THE SPOOL FITS BACK ON BUT WHEN YOU FEED IT, IT OVER ROLLS AND WILL NOT TIGHTEN UP AND YOU END UP WITH LOADS OF TILL ROLL STUCK DOWN THE BACK ???

CAN ANYONE HELP PLEASE

KAREN, September 2008

Hi Karen,
The 203 is usually used in receipt mode, so that would turn the motor off, as the paper should come out of the top of the printer cover instaed of onto the takeup spool.

Are you sure you had it winding onto the spool before? Did you pull a big load of used paper off the spool when changing the roll?

Mark, September 2008