Ali asked ... Replace wires to circuit board correctly?    |    Colin Porch asked ... Stannah 420 batteries?    |    Am asked ... How can I mend Smeg Dusf636x main oven?    |    Robert Loikith asked ... How to mend my Hoover Hushtone CH54115?    |    Mark asked ... Countax site on mower C300h?    |    Click here to ask your question

My shower does not produce any water?

My shower still has power to it as the red stand by light is on and when you turn the dial the light moves from stanby to on yet no water comes out. Can you advise?
Dan, September 2008
a solenoid should have a reading of 3.4 ohms or above don't matter on what make it is.
any less its faulty.

hi-spec plumbing & heating (essex), September 2008
Check the incoming water solenoid.You will need the ohms reading from the manufacturer. Then you will need a electrcian with a multimeter.

Tony, September 2008