the full line w/filter on end, that goes into gas tank where can i find one at .. for a hedge trimmer
mike, January 2019
how to remove the strimmer head
gerry kav, August 2018
i know this is nothing to do with the question above but got one of the paicesetter strimmers a few days ago would not start at all put new plug in still the same 2 hours later found there is points and condenser behind the pull start housing take the 3 screws out remove the pull housing then 12mm nut then the round aluminium piece is threaded and screws off then the points are there it sorted mine out
ady, July 2011
if it is the same Nikki 6050 that Toro uses, you can get one at Tulsa Engine Warehouse for < $14 incl shipping. But it has only the gaskets and diaphragm
husqyjim, April 2009
email address below is wrong!!!
apologies for giving old one, its realwelshdruid@hotmail.com
Tom, October 2008
I have an old one in working order, i have just upgraded.
email me your address if your interested, all it will cost is postage and packing just want to get rid need the space.
Regards,
Tom
realwelshdruid@msn.com
Tom, October 2008
I got mine from a local small equipment rental & repair shop. Or you can try these sites:
http://www.de-errick.com/index.php?go=main.ProductView&product_id=1
Hi Bob, I've found this spares site on the net and have the diaphragm that I needed might help you. Worth looking at Paice setter parts and serial number I have is KQ20 which produced sum results.
Good Luck,
Harvey
Harvey German, October 2008
Hi I am looking for the same if you find one, If i do then I'll email you if you can email me your email address.
