Toddy asked ... Pdw5048tms saw?    |    Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    Click here to ask your question

home Fix label Garden Tools label_important Chainsaws category McCullough

McCullough Eager Beaver 14" Chainsaw WT carb problem?

This saw starts well and appears to run out of fuel after 10 sec. I have checked cap vent, fuel lines, filters and stripped down, found miniuum dirt, daiaframs appear ok.
Brian Forbes, October 2008
home Fix label Garden Tools label_important Chainsaws category McCulloughdone
My Eager Beaver 10" runs great after it warms up, but restarting is a problem. Don't use the choke and trigger the throttle full bore to start, then press throttle on and off like you're shooting a gun. Gas to oil ratio is 50:1

Beavis, January 2009
check filter inside fuel tank floating on end of fuel line

charlie, December 2008
link Click here to see other fixes for McCullough Eager Beaver 14".

Fix Fault - Garden Tools

home label Garden Tools label_important Chainsaws

how do i tighten the on a spear and jackson electrick chane saw?

Garden Tools > Chainsaws > Spear & Jackson

What Broke on both my Husqvarna 350 and Rancher 455?

Garden Tools > Chainsaws > Husqvarna

no oil?

Garden Tools > Chainsaws

Gardenline cs5300b-4 hard to pull chord?

Garden Tools > Chainsaws > Gardenline

i can not find out where the black wire connector connects on craftsman ch8?

Garden Tools > Chainsaws > Craftsman

roybi chainsaw not starting?

Garden Tools > Chainsaws > Ryobi

file?

Garden Tools > Chainsaws > Gardenline

ryobi petrol chainsaw problem with fuel ?

Garden Tools > Chainsaws > Ryobi

Fix Fault - Garden Tools

home label Garden Tools label_important Chainsaws

fixfault.com

fixfault.com for free repair help, information and advice.

How can I fix my Creda Solar Plus?
How can I fix my TEC MA-1400?
How can I fix my Simpson EZIset 750?
How can I fix my Carver Cascade Rapide?
How can I fix my Moulinex Ovatio 3?