The machine selector starts clicking around by itself with the power light flashing three times at ten second intervals. Does anyone know what the three flashes signify.
It would be great if any one could help ?
Neil
October 2005

Neil, October 2005

I have the same problem but my RED light flashes on and off , then the lock light stays on and water enters the soap draw. The the program selector knob just keeps clicking and turning. I have looked at my PCB and my EPROM is soldered in. Could it be the same problem or related to something else ?

Thanks

Richard, March 2006

Thanks luke and kev kinspectorgadget, I was able to sort the problem out because of your info you supplied
Many Thanks again
Neil

Neil, October 2005

check that your thermistor and module are wired up correctly

luke, October 2005

because the knob only tells the circuit board what to do it is only a selector the fact that it is clicking means the machine has sensed a fault with itself. to rectify ramove rear panel access circuit board note/photograph all wires & connections disconnect pcb all wires. you will see a small plug in microchip (an eeprom) pull it out pcb and short all pins together on something metal reassemble & try again if fault re occurs then something else has been sensed by pcb then check for pump out motor action heating and filling ok good luck hope it helps

kev kinspectorgadget@tiscali.co.uk, October 2005