GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

Iveco daily starting problem?

Hi i've just had an engine replaced in my 1998 iveco daily 35/10 (2.8 turbo) it all seemed to be fine ran ok etc, it was left sat for a while, i have gone to start it and it cut out and won't start again, it turns over, fuel seems to be getting to injectors (may have been air in line but seems to have gone) but still won't start i have heard about a fuel cut off could it be that? any ideas would be much appreciated thanks.
sam, October 2008
Starts fine when cold , But when at operating temp has to spin a lot and slowly starts to start, Let it sit for two hrs and will start instantly

Steve Sylvester, August 2018
Hi,
I have a 2003 Mk 3 Iveco Iris Bus Daily and you have to turn the ignition key, press a button on the dash to turn on the ignition lights, then further turn the key to start the engine.
I can start the engine with this sequence several times then suddenly, if you go through the sequence of turning the key, press the button on the dash and no lights come on and just nothing happens. Leave the vehicle for half an hour and it will start using the same sequence. Does anyone have experience of this problem as I just don't have a clue.
Thanks in anticipation Dave C.............

Diggerdave, May 2015
non start cold or hot

vito, October 2014
non start cold or hot

vito, October 2014
i have a problem the car ticks over but dies out when reved do u have any idea what the problem could be

mr stewert, August 2012
mi camion iveco no arranca ni esplosiona ¿que puede ser?

jaime, May 2012
My Iveco has failed to start and is showing me a key lock on the dash what can i do to get it running?? thanks

Clive, April 2012
hi,i have an iveco daily 2.3 wont start cold,if i tow it,it will start with a turn of the wheel,once its running it runs fine but if you stop it for more than 10 minutes wont start just spinns over,if you stop and start it it's fine,changed heat plugs no difference,any ideas cheers.

paul, January 2011
i got a 49.12 van, keeps cooking stater motors, done 220000km, 2nd engine rebuild, the 1st one just a dropped a valv, this one now big $$$ all pistons all injuects big end bent crank....has been well maintain(we thought)
any one else same drama's??? on this model

sstevee, December 2010
hi iv just fitted new engine to my 59/12 i have to use easystart every time it starts and lose power on any type os gradient any ideas what it could be thanks ian

ian, November 2010
i have ievco 02 that turns over but will not start

ricky, November 2010
my iveco daily had the not start when hot problem and is now fixed but im sorry to say its an expensive repair. £600 +vat to recondition the 4 injectors , the seals were gone . this can be tested with a simple leak test on the injecters, should cost aprox £45 to test

lee stevens, July 2010
i have a 06 iveco daily 3.0 only 34k on the clock and it wont start when warm/hot/operating temperature , when its cold i.e. left overnight starts fine . i have bled it on the four injectors when hot and i have fuel at all four but still wont start untill it has cooled. if i use easy start if will start straight away?. can anyone help???. regards lee

lee stevens, June 2010
i have the same problem and its some thing to do with the imoberliser on the ecu it stops the fule

timxx1972, January 2010
i have the same problem turns over wont start getting diesel to injectors just puffs of white smoke but wont start

george, January 2010
the reason your iveco is turning over but not startin unless you spray easystart is that the timing chain may have slipped this happened to me!!

karl, December 2009
hi
i have a starting problem only when engine is cold i turn the key the engine turns over puffs off white smoke apier then about 5mins later it starts .
now ive checked the fuel side off things out replaced cambelt just had full service but still the problem is here, can any one help me.

keith jones, March 2009
i want to buy a ivco daily(1990-2000) version and i would like to know if is any reason why i should not buy this van,i heard that the newer versions are not as good

neil, March 2009
any one still getting problems with there iveco daily vans or iveco all up

bill, March 2009
My iveco would crank but not start. It turned out to be the ignition barrel, it has 2 x 12volt rails and the rail that is used for stating (ignition, injectors)was cooked. The rail that feeds the dash lights and accessories was fine, so appeared to be working.

David, February 2009
Hi guys, I have a 50C13. It just cut and won't start again using the starter. If I spray quick start or push start it then it fires up. The engine turns over when I turn the key, just won't fire. I thought it could be a voltage drop of sorts, so I had the other van boost it, still nothing. Any ideas?

Jacques, January 2009
hi tom, turned out to be an airlock in fuel system bled it through and started it with tin of cold start seems to be fine now hope you have same luck mate

sam, October 2008
no not yet mate still confused, waiting for workshop manual in post,

sam, October 2008
did u get it sorted if so what was it as i am having same problem now thx.

tom, October 2008
link Click here to see other fixes for Iveco Daily.