my servis washing machine doesent drain after finishing the cycle

daryl, October 2008

done everything of the above now how do i check if the pump is working thanks

tom, November 2009

Drain machine by running the outlet pipe into a bucket at floor level. Check the filter unit for blockages.Filter generally located behind a panel at the foot of the machine.Some are obvious like little square hatches and some are hidden behind the trim panel at the foot of the machine. Once panel is removed the filter should be visible. Its generally a circular plastic fitting which unscrews in an anticlockwise direction. Some hotpoint, indesit and ariston filters are located in the big black sump hose (the one that leaves the bottom of the outer drum and connects to the pump). Remove the back cover, locate hose, remove the tensioner clip by squeezing the tabs together, remove the hose, take out filter and clean.
Disconnect pump from sump hose and check for obstruction in either item. Pump removal: power off, remove cover, locate pump, (attached to other end of drain pipe).undo 2 wiring connections, 2 hose connections, and pump mounting screws. Remove pump chamber - some are held in with screws, others clip into place. Check for foreign objects round the impeller. If pump chamber is clear, may be a fault with the pump motor - in which case, replace.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy, October 2008

have you checked the filter is clear and your drain pipe is also clear the filter is usually near the bottom behind a flip down door of some kind.if the machine is full of water you will get a wet floor so be warned!.

coges, October 2008