GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

homelite chainsaw fuel lines replaced?

My homelite 45cc 18" chainsaw fuel lines, filter and primer bulb were replaced. After priming, the saw will run until the gas pumped in from the priming is gone; It will only stay cranked long enough to burn the gas from priming. Can anyone give me some advice on what to check?
limbs down, November 2008
try changing the priming bulb pipes over, as the priming bulb sucks fuel up the pipe that goes from tank to the carb then through the priming bulb back to tank in that direction.

armyof1, July 2009
If the main line is clear, you'll probably need to clean out the carburetor, which will likely require a diaphragm/gasket kit. Many sites carry them. You probably have a Walbro carburetor. Just google "Walbro carburetor kit".

Jack, December 2008
I have replaced all the fuel lines (they were rotted out) and the prefilter; now it does start each time I prime it, But after priming gas has burned it dies. Its as if I can only get gas in the carb from priming but it will not flow otherwise.

down limbs continue, November 2008
I have replaced all the fuel lines (they were rotted out) and the prefilter; now it does start each time I prime it, But after priming gas has burned it dies. Its as if I can only get gas in the carb from priming but it will not flow otherwise.

down limbs continue, November 2008
sounds like one of the lines has a crack in it or has come off of the carb

pat, November 2008
check the main fuel line that runs from the tank to the carby and little filter inside carby could be blocked

frail, November 2008
link Click here to see other fixes for Homelite.