Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Problems with Veritas R8 alarm system?

We have recently moved into a new home with a Veritas R8 alarm system fitted. We have been using the code as given to us by previous owners (who left no user guide) however when you enter the code the alarm beeps contiuously till you enter the code again and the tamper light is permanently illuminated red. We have since found instructions to change code and have done so but still have the same situation with the beeping and the red tamper light.

Can anyone point us in the right direction as to how to investigate or fix the tamper problem or why the alarm does not set properly (i'm assuming the constant beeping mens it is not set properly).

Many thanks
Julie, November 2008
hello! Yesterday we had a power cut and my alarm does not work, when I key in the code the buttons does not respond. Do you think it is the battery? The keyboard illuminates, I checked the fuse and the alarm went off!
Please help!!
Christina

christina, December 2008
Does the alarm sound with 9 beeps which is then repeated ?

If so it's a tamper fault and you need to look at each sensor/detector and the bell box for a tamper fault.

It may be better to get an alarm engineer in

Mr Handy Andy, November 2008
The alarm does not set as you have a tamper fault.

Best bet is to get an alarm Engineer in

Mr Handy Andy, November 2008
link Click here to see other fixes for Veritas R8.