Rear Brakes:- I can't get the hub off. It does not have the release on the back like normal.

Autumn, November 2005

you need to go through the back of the hub witha screwdriver and wind the brakes off, this is done by turning a small wheel,to check that your going the right direction periodically turn the wheel, absolute pig of a job, you will need a torch, approximately six inch flat bladed screwdriver and a whole lot of patience, good luck,

Chris O, December 2007

to remove the hub all you have to do is knock a stud through the drum allowing u to get to he cable adjuster using a flat blade screwdriver u can slacken the cable allow the drum to come off

mike, September 2006

i have recently done mine u have to ensure hand brake is off.
begin by tapping around the drum to free the rust. then u will need a hub puller/slide hammer. they are very tight? it took a good half hour of hammering to remove it.

dave (hull), November 2005