3 hours ago Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

How to reassemble my Creda 37373 Tumbler Dryer?

I've a new rear bearing but not sure whether the washer at the rear goes on the outside (next to the spring clip) or on the inside next to the drum
Bemused, December 2008
Your washer will go against the drum..

sal bassi, December 2008
seen them on either side , check position of drum at front in relation to bearings and make an informed decision. there may be a mark left on the cabinet from where it was previously

the doctor, December 2008
link Click here to see other fixes for Creda.