Steve asked ... Gilera runner 180 vxr 2001 ignition replacement?    |    Janboy68 asked ... How can I mend my KitchenAid Artisan toaster?    |    rick asked ... How can I fix my portable Zenith DVP615 DVD player? When I p?    |    Jim asked ... How can I get my scarifier to work?    |    george crawford asked ... Citroen C3 Picasso?    |    Click here to ask your question

FP Smart Drive9 Excellence 7.5 - 7yrs old?

Part way through wash cycle, washer stops with intermittent beep. Re-balance clothes, gets through to end of rinse (empty bowl) and stops with a constant beep.

Light error is as follows (x is light on)
o o x o o x o x
First five are the wash cycles so middle green light is on
6th & 7th are Rinse, first orange light is on
8th is Spin, one & only red light is on.

All lights are steady on, no flashing. Have turned off & on, haven't tried starting again.

Any hints would be greatly appreciated.

Thanks
Peter, December 2008
That is great, thanks for the information, greatly appreciate your time.

Regards,

Peter, December 2008
This is fault code 37. Means pump problem. Water level has taken too long to drain out. The fact that you say bowl is empty after awhile suggests a partial blockage. When machine is pumping out there should be a strong flow of water from the drain hose. If not then empty the bowl, remove the pump and check inside the hole where the pump sits for any rubbish.

Lincoln Appliance NZ, December 2008