Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

how can i replace starter solenoid?

what is the proper placement of the wires on my MTD starer solenoid?
greg haugen, August 2004
Solenoids are pretty well all the same. They have two large nuts, one on each side for your large wires, one from battery and one to the starter. Below there can be 1 or 2 posts if yours has only 1 then purchase one with only one. It goes to the ignition switch. The second pole is only for ground, if required. Disconnect your ground on your battery and change it over the reconnect it and that should do it.

JOHN at Rona, September 2004