59 mins ago Stuart G asked ... C3 Front Wiper control problem?    |    4 hours ago Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

028 wb super av oil problem?

when saw is running bar oil running out from under bar cover and only small amonts on chain. saw is very clean .....?
tek440, January 2009
Remove the pump & gasket , clean the suction channel, then replace the gasket with a new one Reinstall the pump.

Curtis, April 2009
make sure the oil port is clean against the bar as the oil may be just running down the backend of the Bar + what Tony said - top advice

Steve, February 2009
make sure the ports are cleaned out, and also the holes in the cutter bar, clean it again.

Tony, January 2009