hot point model wm 55 when in cycle it spins and drans fine but when it goes to rines it keeps filling up until it over flows out of the soap draw could this be problem with programme selector dial everthing else is fine

s j h, February 2009

Sounds like the first 6 way plug near the front of the timer is burning. Unplug machine & clean out plug. If the timer is also burnt, we supply them for £44.90+vat at :

http://www.emwelec.co.uk/index.php?action=item&id=7&prevaction=category&previd=1&prevstart=0

Tony
EMW Electronics
tel 01159652118

EMW, February 2009

check pressure switch, for a split pipe, or more likely a blocked pressure chamber hole
remove top of machine locate the pressure switch round thing with wires and a plastic pipe remove the pipe from switch and check for any possible splits where it could rub the casing if OK blow down the pipe if you go red pipe is blocked ,follow and locate the other end of the plastic pipe and remove, now clear the blocked hole with a stiff piece of wire
blow up the pipe and you should hear the switch click
reassemble the pipe end and allow machine to fill.

wirecutterman, February 2009