when I turn on the power button the only thing that happens is the time dislay shows E7 and pressing the mode button does no good nothing happens.

Gary, February 2009

my tradmill just stopped during a workout no key for it either

shana strohn, October 2020

My teadmill has a 3 code how do I fix it please help my model is a tx 455 sport craft

j.t, October 2011

Hi there...I just purchased a tx455 and need to replace the belt, but desperately need the manual or some deatiled directions. HEEEEEELP! :o)

Danielle, September 2010

sportscraft tx455.
where does the safety key go and it doesn't turn on. do i need a new safety key or board. thanks.
i plug it in does turn on.

MISS TAINA, September 2010

E3 – No speed sensor reading. Unit shuts down. This is the most difficult repair diagnose. The speed sensor is connected to the frame of the treadmill near the drive pulley on the front roller. There is a small magnet on the side of the pulley wheel. The sensor tip must be no more than 5mm from the magnet. If for any reason the distance is greater than 5mm the treadmill will shutdown

Devin, June 2010

I found that the speed sensor wheel on mine wouldn't stay on, I hot glued it & resest the E 7 code as above, it works great now.

Ken S., February 2010

my treadmill has an e3 reading. The motor does not excelorate. please help.

andrea velasquez, October 2009

Error code E7 occurs when the treadmill experiences a runaway situation or otherwise senses that the speed is not under the control of the console. When the error occurs, you the console locks out and you cannot use the treadmill again until the console is reset. Resetting the console will not necessarily remedy the situation if the electronics are faulty; in that case, the console needs to be replaced. But before you have the console replaced, you can try to reset the console yourself and hope that the error will not recur.

To reset the console:
1. Press and HOLD the MODE and STOP buttons while simultaneously turning the power off by removing the Safety Key.
2. Continue to hold MODE and STOP and replace the Safety Key. The console will beep.
3. Press Speed up ONE time.
4. Release all buttons.

Hope you find this useful.

Rodger Ellis, April 2009

google sportscraft website and there it will have a tab for treadmills get the instruction manual for that treadmill it tells you what to do under that code.

Veronica in AZ, March 2009

Hey The same thing happened to me!! Please help!! :)

Candice, February 2009

try holding down mode and stop at the same time while removing the safety key and then re-insert the safety key.

kristen, February 2009