were does the wiring from the switch go to, My truck is an horsebox and i can not tilt the cab. truck wont start, it is suppected that this may be the problem

gary, March 2009

depending on the model this could be an alternator fault as there is an inhibit relay which is mounted at the left of the fuse box .
if you pull the fuse box forward and join the 2 green wires no8888 then try to start the vehicle .if it starts check alternator system .
if not put a feed to thes cables one of them should start it if this doesnt work check the relays and DIODE block are in the correct position

lecky, March 2009

very unlikely unless the cab tilt light is on. if not it is a relay or fuse board fault, as the fuse boards are printed circuits they crack over time losing contact. look at your fuse box, the relays that run from top left corner straight down are all starter relays, remove the bottom one and you will see five slots where the relay sits, make up a single wire with spade connecters on each end, put one end in the bottom slot this is permanent live put the other end in the top it should start.

brian, March 2009