2 hours ago Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

Homelite carb adjustment?

I have a homelite cs-50. The saw doesnt seem t be reving as high as it did. I am think i may need to adjust the carb. How do i do this and is there a certain number of times to turn the screw. Like 2 full tirns outfor the L and 2 turns for the H. Thanks
frank, March 2009
what do you mean by undo the adjuster

frank, March 2009
The high rev is the "H" setting, warm the unit up, rev the knackers off it and adjust the "H" setting so it revs fully then undo the adjuster so the motor just burbles and you are spot on, if you adjust the "H" setting leaner than this, it can seize the engine when used on full bore so be warned!

Steve, March 2009
link Click here to see other fixes for Homelite.